Long DVI Cables - Premium DVI-D Single Link, Extra Long DVI cable
DVI to DVI cables for extended distances
Our Super Long Distance DVI cables use a specially developed and optimised cable material that allows longer cable distances than the 22.5ft maximum recommendation laid down by the DDWG (Digital Display Working Group).
- DVI-D Single Link Cable
- For use with all modern digital monitors, projectors and TFT/LCD Flat Panel Displays
- UXGA (1600 x 1200) and HDTV1080i (1920 x 1080) compatible
- Patent pending, RF-BLOK shielded design
- Connectors: DVI-D Single Link Male to DVI-D Single Link Male
- 10 Year Warranty
Just one of our huge range of DVI cables and DVI cables, which also includes Premium Gold DVI-D Super Long Distance cables and DVI cables with analogue support.
Additional Information
Please note: Maximum supported distances and resolutions are dependent on both the monitor and the chipset used in the graphics card. The following example shows the maximum values from a test with a Belinea 1280 x 1024 DVI flat panel display and two different graphics cards (ATI Radeon 7000 and NVidea 5200).
As a general rule, the newer the hardware used, the longer the distance and the higher the supported resolution.
Our SLD cable length
|
Max. resolution using a 2004 Belinea TFT (1280 x 1024 native resolution)
|
Max. resolution using a 2006 Dell TFT (1920 x 1200 native resolution)
|
60ft
|
1280 x 1024 @ 60Hz
|
1920 x 1200 @ 60Hz
|
75ft
|
1024 x 768 @ 60Hz
|
1600 x 1200 @ 60Hz
|
Features of the RF-BLOK shielded design:
- Reduced interference from one piece EMI (Electromagnetic Interference)/RFI (Radio Frequency Interference) shield
- Increased insulation resistance up to 25%
- No soldering requirements as interconnect design needs no 360 degree soldering - eliminating the possibility of human error and/or cracking of the solder that causes grounding intermittence and the use of the most hazardous waste material - soldering flux
- Tight fit of internal wires as there is no inner mould
- No requirement of ferrite cores as signal loss and degradation are greatly reduced giving enhanced signal sharpness. Without the ferrite cores the cable is less stressed and more flexible
- Smaller overall dimensions which allows more room behind the host or peripheral
- Increased connector and mating strength - the 4 point reinforcement tabs on the RF-BLOK, attached to the connector, strengthens the pair as one
|